Dometic TEC 40D Operation Manual de Instalação descarregar pdf (Página 19)

user’s manual

TEC 40D

Battery connection

N.B.

To start the generator it is necessary to use a 12VDC battery, with a minmum

capacity of 60Ah.

To start the generator, connect it to the positive pole of the vehicle’s battery

with a sheathed cable of a suitable cross-section as shown in the table. The

ground cable must have the same cross-section and be connected or as

shown in the ﬁgure to the side or from the inserts to the frame of the vehicle.

Make sure that the contact is good. If necessary remove paint or rust from

the surface of the frame and protect the connection with grease.

To protect the DC wiring use a 100 Amp fuse closed to the plus pole

of the battery.

External control panel connection

Choose the desired position inside the vehicle, use the extension

lead (supplied) to connect the external control panel to the internal

control panel of the generator.

(+) Plus

pole

(-) negative

pole

2 Installation instructions

�

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 27 28

Sem comentários

Dometic TEC 40D Operation Manual de Instalação Página 19