Dometic CA2500 Manual do Utilizador descarregar pdf (Página 23)

Dometic CA2500 Installation

➤ Make an opening on one side in order to feed through the electrical

power supply cable.

7.2.2 Installation in an existing sunroof opening

Note

Existing roof hatch openings of 400 to 435 mm are suitable for the instal-

lation of the roof air conditioner. If the opening for the installation of the

device is larger than 435 mm, it is possible to reduce the roof opening us-

ing a self-made frame. The roof hatch opening for the installation of the

device should not be larger than 450 mm.

Note

The manufacturer only assumes liability for parts included in the scope of

delivery. The validity of the warranty expires if the device is installed to-

gether with third-party parts.

Caution – risk of damage

Please observe the structural engineering of the vehicle and seal of all

openings made when installing the roof air conditioner.

Removing the roof hatch

➤ Remove all screws and fixtures of the existing roof hatch.

➤ Take out the roof hatch.

➤ Remove the sealant around the opening using a scraper or similar tool

(fig. 5, page 3).

➤ Use a sealant to seal the bore holes (fig. 6, page 3).

Note

Dispose of all waste material, glue, silicone and seals separately. Ob-

serve the disposal guidelines.

7.2.3 Laying the power cable (fig. 7, page 4)

Caution – danger of electrocution

Make sure there is no voltage at electrically operated components before

carrying out work on them!

➤ The roof air conditioner must be connected to an electric circuit which

is able to supply the required current.

_IA_CA2500.book Seite 23 Montag, 16. Juni 2008 2:29 14

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 119 120

Sem comentários

Dometic CA2500 Manual do Utilizador Página 23