Dometic DS600HFS Manual do Utilizador descarregar pdf (Página 5)

attached stand or alternatively it can be fixed to the

refrigerator door, in which case the sensor wire should

be arranged so that it is not stretched or damaged when

the door is opened.

The temperature sensor is located inside the refrigerator

below the bottom shelf.

The display will then show the current, maximum and

minimum temperature inside the refrigerator.

After the first pull down of the refrigerator (allow four

hours) please make a "reset" on the thermometer

because otherwise it will keep as "maximum" the

ambient temperature.

If you find lower than +2 °C or even negative

temperature as a minimum on the screen, it must have

occured due to a cutout in the electrical circuit. In these

circumstance's the electronic thermostat will make a

restart and start to cool down the refrigerator, without

monitoring the refrigerator for 45 minutes. If you reset

the thermometer again (1-2 hours later) and the normal

+2 ... +8 °C is shown then you can be sure that the

medincines have not been damaged or frozen.

The more medicines you store in the refrigerator then

reduces the hazard of freezing, if the unit has a short

period of time undercooling.

We take no responsibility for damage to vaccines

through freezing, if there has been a cutout in the

electricity for a short period of time.

It is important to reset the thermometer regularly to

ensure that the temperature is maintained between 2 °C

and 8 °C.

The temperature readings may rise temporarily after

opening the door or placing additional items inside the

cabinet.

On the battery transit strip must be removed to activate

the temperature display.

Figure 4.

7. Useful suggestion

Do not overfill the appliance. It is advisable to leave

some space between the products in the cabinet to

ensure efficient and even cooling. If the shelves are

packed too tightly there may be unacceptable

temperature variations.

4. Positioning the appliance

When first using this refrigerator please consider the

following points:

ENSURE REFRIGERATOR IS LEVEL

THE PIPEWORK AT THE BACK GETS HOT IN USE

THE REFRIGERATOR HAS NO 'MOTOR' AND IS

THEREFORE VIRTUALLY SILENT

ALLOW AT LEAST 3 HRS. FOR SIGNS OF COOLING

During the refrigeration process, the appliance gives

off heat from the condenser (under the upper part of

the rear cover) into the surrounding air. The more ventilated

the condenser is, the more effective the refrigeration will

be.

The other condition for satisfactory operation is that the

appliance stands on a flat surface. This is best seen by

placing a glass of water on top of the appliance.

It is important that the appliance is not directly exposed

to radiated heat (sunlight, radiator, near an oven, etc.).

Please do not place the refrigerator onto thick carpet!

4.1. Installation instructions

This version is supposed to be freestanding. Cooling unit

room cover protects from the hot parts of the cooling unit.

Foot frame with grilles ensures sufficient ventilation.

5. Using the appliance

To start the refrigerator connect the plug to the socket

outlet and switch on the socket. The cooling fins should

show signs of cooling after about 1-2 hours depending on

ambiant temperature.

5.1. Initial operation

The device must be plugged into a properly earthed

socket.

The miniCool starts automatically with a self-test. The

LED illuminates after plugging-in several times and after

that continuous light can be seen if the door is open.

The miniCool achieves its operating temperature after

several hours.

5.2. Temperature regulation

The usual setting required is in the region of the middle of

the thermostat knob (Fig. 3), but this can vary with

conditions of load and installation. If it is found necessary to

alter the setting,the knob can be turned to a higher symbol

to produce a colder temperature, or a lower symbol to

produce a warmer temperature. The effect of any

adjustment can be checked by means of a thermometer

after leaving the refrigerator operating for a further period to

settle down again.

Figure 3.

6. Thermometer (Fig. 4)

Refer to the separate instruction leaflet supplied with the

thermometer. The thermometer can be stood up using the

1 2 3 4 5 6 7 8 9

Comentários a estes Manuais

Sem comentários

Dometic DS600HFS Manual do Utilizador Página 5

Comentários a estes Manuais

Manuais e produtos relacionados com não Dometic DS600HFS