Dometic RM7030 Instruções de Operação

1INSTALLATION &OPERATING INSTRUCTIONSMODEL RM7030Automatic Energy SelectorREFRIGERATOR FOR LP/GASAND ELECTRIC OPERATIONRECORD THIS INFORMATION FOR

10from drying out, keep it in covered dishes, containers, plasticbags or wrapped in aluminum foil.C. ICE MAKINGIce cubes can be made in the ice tray p

1110) Reinstall burner, being careful that the end of theburner fits into the slot on the burner bracket. Checkto make sure slots are centered under

121. REFRIGERATOR REMOVALBefore working on the refrigerator, make sure the AC voltageand DC voltage leads are disconnected. Shut off the gassupply. Di

13CONTAINER DURING THE FIRST CYCLE.The first few cycles may have small cubes due to airtrapped in the water lines. The first container of icecubes sh

14611CSBLBLACKBROWNREDORANGEGREENA5B5C5D5E5B2A2WHITEWHITEJ6J5J4J3J2J7J10J8OPAA3B3C3FG7123UNNKH2MR2+-124P3E451IJ12V DC2D211122WHITEYELL OWBLUETTT1120 V

2SECTION A. INSTALLATION2.VENTILATIONThe installation shall be made in such a manner as toseparate the combustion system from the living space of them

35.VENTILATION HEIGHTSRefer to FIG 1., Page 2Installation with roof Minimum Ventilationvent and lower side vent heights in:REFRIGERATOR INCHES MMRM703

47. INSTALLING REFRIGERATOR INENCLOSURENOTE: DO NOT install the appliance directly on carpeting.Carpeting must be removed or protected by a metal or w

5E. Remove cover (see FIG. 6) and open the manual gasvalve. Apply a noncorrosive commercial bubble solutionto burner jet (see FIG. 6).F. No bubbles sh

6plug. The free length of the cord is 2 feet and thereforerecommended that the receptacle be located to the right sideof the refrigerator (viewed fro

7F. Slide door panel into BOTTOM of freezer door, makingsure it slides into top groove.Reverse Steps A through E to replace door.Install decoration st

82.CONTROL PANELLEGEND 2-WAY AES MODEL1. Main Power Button ON/OFF2. AES Mode Selector Button3. Temperature Selector ButtonA. AC Mode Indicator LampB.

9from "COLDEST" to the desired temperature setting, usuallyabout mid-setting.G. STANDBY MODE OF OPERATIONThis control system contains a feat