Dometic RM2453 and Instruções de Operação descarregar pdf (Página 6)

Replace the top decoration panel.

Make sure the tabs snap back into the holes in the hinge

plate.

STEP 3: Two screws installed in the rear base.

See FIG. 8.

Failure to follow the sequence in securing the refrigerator

in the enclosure can cause leakage between the frame

and cabinet. Any space between the counter, storage

area or ceiling and top of the refrigerator greater than

40 mm should be blocked. The heat produced at the

rear of the refrigerator will become trapped in this space,

making the top of the refrigerator hot and reduce the

efficiency of the refrigerator.

LP GAS CONNECTION

The refrigerator is designed for operation on LP-gas, the

pressure of which must be 2,7 kPa for Propane.

Check that this is stated on the data plate.

The refrigerator is not designed for operation on

town gas or natural gas.

Hook up to the gas supply line is accomplished at the

manual gas valve, which is furnished with a ISO 7/1 -Rp

1/8 internal pipe thread connection. All completed con-

nections should be checked for leaks with soapy water.

FIG. 7

FIG. 8

DO NOT use a flame to check for gas leaks.

The gas supply system must incorporate an approved

gas pressure regulator to maintain a supply pressure of

2,75 kPa .

When testing the gas supply system at test pressures in

excess of 1/2 psi, the refrigerator and its individual shutoff

valve must be disconnected from the gas supply piping

system.

When testing the gas supply system at pressures less

than or equal to 1/2 psi, the appliance must be isolated

from the gas supply piping system by closing its indi-

vidual manual shutoff valve.

In case detailed instructions on the installation and con-

nection to the gas supply are required, contact your dealer

or distributor.

TESTING LP GAS SAFETY SHUTOFF

The gas safety shutoff must be tested after the re-

frigerator is connected to the LP gas supply.

To test the gas safety shutoff, proceed as follows:

1. Start the refrigerator according to the instructions for

LP Gas Operation. See section Operating Instruc-

tions.

2. Check that the gas flame is lit. This can be observed

on the flame indicator E. The red indicator is in the

green field, (ON).

3. Close the gas valve by turning the knob A back to

“OFF” position.

4. Wait for one minute.

5. Remove protection cover (see FIG. 1). Open the gas

valve by turning knob A to position “GAS” without

pushing the buttons C and D. Apply a non-corrosive

commercial bubble solution to the burner jet. Be care-

ful not to damage the burner jet.

6. No bubbles should appear at the opening of the burner

jet. The presence of bubbles indicates a defective

gas safety shutoff, and service is required.

7. If no bubbles were present at the burner jet, the gas

safety valve is working properly. Rinse jet thoroughly

with fresh water before proceeding. Be careful not to

damage the burner jet.

Replace the protection cover and turn the main switch

OFF and back ON. See instruction for LP Gas Op-

eration , section Operating Instructions. Normal op-

eration of the burner should return. Allow the burner

to operate for a minimum of 5 minutes.

! WARNING

1 2 3 4 5 6 7 8 9 10 11 12 13

Comentários a estes Manuais

Sem comentários

Dometic RM2453 and Instruções de Operação Página 6

Comentários a estes Manuais

Manuais e produtos relacionados com Frigoríficos Dometic RM2453 and